Steps
1.
Loosen the captive screws that secure the network daughter card (NDC) to the system board.
2.
Hold the NDC by the edges on either side of the touch point, and lift the card to disengage it from the connector on the system
board.
3.
Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in the back panel.
4.
Lift the NDC out of the chassis.
Figure 65. Removing the NDC
1.
captive screw socket (2)
2.
connector on the system board
3.
captive screw (2)
4.
touch point (2)
5.
network daughter card (NDC)
6.
back panel slot for Ethernet connectors
Next steps
1.
Install the NDC.
2.
If removed, install the expansion card riser 1.
3.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing an expansion card from expansion card riser 1
Installing the network daughter card
Removing an expansion card from expansion card riser 2
After working inside your system
124
