2.
Press out the securing clip at each end of the memory module connector.
3.
Align the notch on the bottom of the module with the crossbar in the connector.
4.
Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
5.
Replace the computer cover (see
Replacing the Computer Cover
).
6.
The computer detects that the new memory does not match the existing configuration information and generates the following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
7.
Press <F2> to enter system setup and check the value for
System Memory
.
The computer should have changed the value of
System Memory
to reflect the newly installed memory. Verify the new total. If it is correct, skip to
step 9
.
8.
If the memory total is incorrect, turn off and disconnect your computer and devices from their electrical outlets. Open the computer cover and check the
installed memory modules to ensure that they are seated properly in their sockets. Then repeat steps
5
,
6
, and
7
.
9.
When the
System Memory
total is correct, press <Esc> to exit system setup.
1 memory connector closest to processor 2 securing clips (2) 3 connector
1 cutouts (2) 2 memory module
3 notch
4 crossbar
NOTICE:
To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the
module.
Summary of Contents for OptiPlex 745c
Page 105: ...Back to Contents Page ...
