11.
Remove the two M2.5 x 8-mm screws that secure the hinges located on the bottom of the computer.
12.
Lift the display and hinge assembly out of the computer.
Replacing the E5400 Display Assembly
1.
Align the display hinges with the holes in the base of the computer, then lower the display into place.
2.
Replace the two M2.5 x 8-
mm screws on the bottom and the four M2.5 x 5
-mm screws (two per hinge) in the top of the computer.
3.
Connect the display cable to the system board.
4.
Slide the antenna cables through the hole in the palm rest and the base of the computer.
5.
Insert the antenna cables into the cable guides where they were originally placed.
1 M2.5 x 8-mm bottom screws (2)
1 display cable connector 2 M2.5 x 5-mm top screws (4)
3 display assembly
4 antenna cables (2)
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTE:
This procedure assumes that you have completed the removal procedure first.
NOTICE:
Ensure that the display cable and antenna cables are properly routed and secured beneath the plastic tabs on the palm rest.Route the
display cable and antenna cables beneath the guide tabs on the palm rest.
Summary of Contents for E5400 - Latitude - Core 2 Duo 2.4 GHz
Page 30: ......
Page 44: ...Back to Contents Page ...
Page 52: ...Back to Contents Page ...
Page 56: ...13 Follow the procedures in After Working on Your Computer Back to Contents Page ...
