Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working in your system section.
3. While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
4. Enter the correct time and date in the System Setup
Time
and
Date
fields.
5. Exit System Setup.
Related tasks
Removing the cooling shroud
on page 65
Installing the cooling shroud
on page 66
Control panel assembly
Removing the control panel assembly
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Remove the optical drive and tape drives.
Steps
1. Remove the screw securing the control panel to the chassis.
2. Disconnect the control panel cable and the control panel USB cable from the system board.
CAUTION:
Do not use excessive force when removing the control panel cables as it can damage the connectors.
3. Slide the control panel out of the chassis.
4. Disconnect the control panel cable and the control panel USB cable from the control panel.
124
Installing and removing system components
Summary of Contents for E35S001
Page 2: ......
Page 164: ...164 Getting help ...
