d. Click
Restore
, and then proceed to step 3.
2.
To manually map volumes, do the following:
a. On the
Disk Mapping
page of the
Restore Machine Wizard
, select the
Manually Map Volumes
tab.
b. In the
Volume Mapping
area, under
Source Volume
, verify that the source volume is selected and
that the appropriate volumes are both listed beneath and are selected.
c. Under
Destination
, from the drop-down menu, select the appropriate destination that is the
target volume to perform the bare metal restore of the selected recovery point, and then click
Rollback
.
3.
In the
RollbackURC
confirmation dialog box, review the mapping of the source of the recovery point
and the destination volume for the rollback. To perform the rollback, click
Restore
.
CAUTION: If you select Begin Rollback, all existing partitions and data on the target drive will
be permanently removed, and replaced with the contents of the selected recovery point,
including the operating system and all data.
Viewing the recovery progress
To view the recovery progress:
1.
After you initiate the rollback process, the
Active Task
dialog box displays, showing that the rollback
action initiated.
NOTE: This appearance of the
Active Task
dialog box does not indicate successful completion
of the task.
2.
Optionally, to monitor the rollback task progression, from the Active Task dialog box, click
Open
Monitor Window
. You can view the status of the recovery as well as the start and end times from the
Monitor Open Task
window.
NOTE: To return to the recovery points for the source machine from the
Active Task
dialog
box, click
Close
.
Starting the restored target server
To start the restored target server:
1.
Navigate back to the target server, and in the
AppAssure Universal Recovery Console
interface, click
Reboot
to start the machine.
2.
Specify to start Windows normally.
3.
Log on to the machine.
The system is restored to its state prior to the bare metal restore.
Repairing startup problems
Keep in mind that if you restored to dissimilar hardware, you must have injected storage controller, RAID,
AHCI, chipset and other drivers if they are not already on the boot CD. These drivers make it possible for
the operating system to operate all devices on your target server successfully.
To repair startup problems:
1.
If you encounter problems when starting the restored target server, open the Universal Recovery
Console by reloading the boot CD.
2.
In the Universal Recovery Console, click
Driver Injection
.
3.
In the Driver Injection dialog, click
Repair Boot Problems
.
The startup parameters in the target server boot record are automatically repaired.
4.
In the Universal Recovery Console, click
Reboot
.
77
