Deitz Pharmafill TC3, Operation Manual

Page: 61 / 84

Rev 2022-03-08 Pharmafill Model TC3 User Manual
Deitz Company Inc. TC3 User Manual Page 49
9.3 - Buildup Of Remove-To-Clean Contact Parts (Summary) (Cont’d)
17. Disconnect the
Counting Sensor Electrical Cable . First, slide the black collar down
to unlock the cable, then pull down on the connector to disconnect the cable. (12)
18. This is the top of the machine with contact parts removed. Wipe down as needed.
Make sure the
Rim Groove is clear of any dust or debris. (11)
19. Carefully lift and remove the
Glass Disc (with Aluminum Support Disc attached).
Note that the support disc has a slot which aligns with a pin on the drive hub. Make sure
this is oriented correctly when you install the glass again. (10)
20. Unscrew the Disc
Hold-down Ring Nut. Remove the Plastic Hold-down Washer .
(9)
21. Remove the
Center Hub Assembly by removing the center knob. (8)
22. …rotate the
Air Guide Assembly up and out of the way (7)
23. Pull out the
Manifold Release Pin , then... (6)
24. Remove the
Adjustable Product Guide Assembly by removing the adjustment
knob.. (5)
25. Remove the Rim Band from the groove in the top cover by lifting it up, starting at
one end and working around. (4)
26. Remove the
Clear Rim Cover by loosening the hold-down screw in front and the
mounting screws in back and sliding the cover forward. (3)
27. Remove the
Auto-feed Sensor Cable from the Auto-feed Sensor , by unscrewing the
knurled ring at the end of the cable. (2)
28. Remove the
Chute Clear Cover by loosening the mounting knob at the bottom and
sliding it off. (1)