Deitz Pharmafill TC3, Operation Manual

Page: 51 / 84

Rev 2022-03-08 Pharmafill Model TC3 User Manual
Deitz Company Inc. TC3 User Manual Page 39
Section 9 –BREAKDOWN, CLEANING AND BUILDUP
9.1 - Breakdown Of Remove-To-Clean Contact Parts (Summary)
NOTE: The line numbers below refer to the illustration in the next section.
1. Remove the Chute Clear Cover by loosening the mounting knob at the bottom and
sliding it off.
2. Remove the
Auto-feed Sensor Cable from the Auto-feed Sensor , by unscrewing the
knurled ring at the end of the cable.
3. Remove the
Clear Rim Cover by loosening the hold-down screw in front and the
mounting screws in back and sliding the cover forward.
4. Remove the
Rim Band from the groove in the top cover by lifting it up, starting at one
end and working around.
5. Remove the
Adjustable Product Guide Assembly by removing the adjustment knob..
6. Pull out the
Manifold Release Pin , then...
7. …rotate the
Air Guide Assembly up and out of the way
8. Remove the
Center Hub Assembly by removing the center knob.
9. Unscrew the Disc
Hold-down Ring Nut. Remove the Plastic Hold-down Washer .
10. Carefully lift and remove the
Glass Disc (with Aluminum Support Disc attached).
Note that the support disc has a slot which aligns with a pin on the drive hub. Make sure
this is oriented correctly when you install the glass again.
11. This is the top of the machine with contact parts removed. Wipe down as needed.
Make sure the
Rim Groove is clear of any dust or debris.
12. Disconnect the
Counting Sensor Electrical Cable . First, slide the black collar down
to unlock the cable, then pull down on the connector to disconnect the cable
.
13. Remove the Counting Sensor Cover . Slide the Counting Sensor to the right to
remove it from two the mounting pins.
14. Remove the
Counting Window and Counting Sensor as one unit. Do not disconnect
the fiber optic cables from the top of the Counting Sensor.
15. Remove the
Funnel Holder and the Funnel .