degdrive DGI900, User Manual

Page: 171 / 251

171
(FMR) .
P4.01
FMR function (open-collector
output terminal)
Setting Range
：
0
～
41 0
P4.02
Relay function
（
T/A-T/B-T/C
）
Setting Range
：
0
～
41 2
P4.03
Extension card relay
function
（
R/A-R/B-R/C
）
Setting Range
：
0
～
41 0
P4.04
DO1 function selection (open-
collector output terminal)
Setting Range
：
0
～
41 1
P4.05
Extension card DO2 function
Setting Range
：
0
～
41 4
These five parameters are used to select the functions of the five digital output terminals.
T/A-T/B-T/C and P/A-P/B-P/C are respectively the relays on the control board and the
extension card.
The functions of the output terminals are described in the following table.
Table 6-3 Functions of output terminals
Value Function Value Function
0 No output 1 AC drive running
2 Fault output (stop) 3 Frequency-level detection FDT1 output
4 Frequency reached 5 Zero-speed running(no output at stop)
6 Motor overload pre-warning 7 AC drive overload pre-warning
8 Set count value reached 9 Designated count reached
10 Length reached 11 PLC cycle complete
12 Current running time reached 13 Frequency limited
14 Reserved 15 Ready for RUN
16 VI larger than AI 17 Frequency upper limit reached
18 Frequency lower limit reached
(no output at stop)
19 Under-voltage state output
20 Communication setting 21 Reserved