Datalogic PowerScan Series, Product Reference Manual

Page: 69 / 411

RS-232/USB-COM SETTINGS ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
53
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
ACK Character" on
page 317
for more detailed programming instructions.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
NAK Character" on
page 318
for more detailed programming instructions
NOTE: Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit data
is not recognized when the option "
Data Bits" on page 46
has been set as 7
Data Bits.
Select ACK Character Setting
$CR2AC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

0x06 ‘ACK’ Character
NOTE: Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit data
is not recognized when the option "
Data Bits" on page 46
has been set as 7
Data Bits.
Select NAK Character Setting
$CR2NA
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

0x15 ‘NAK’ Character