CLEARING DISPLAY
PRODUCT REFERENCE GUIDE
345
CLEARING DISPLAY
LED AND BEEPER CONTROL
The LED control escape sequences are intended to activate the LEDs for short periods of
time and can be used in combination with the Beeper. The LED and Beeper will be con
-
trolled by the system after the entire command sequence is interpreted.
Example:
SETTING RTC
ESC SEQUENCE
ACTION
ESC [ 0 K
From cursor position to end of line inclusive
ESC [ 1 K
From beginning of line to cursor position (not inclusive)
ESC [ 2 K
Entire line
ESC [ 0 J
From cursor position to end of display inclusive
ESC [ 1 J
From beginning of display to cursor position (not inclusive)
ESC [ 2 J
Entire display; moves cursor to upper left corner on display
ESC SEQUENCE
ACTION
Esc [ 0 q
Emit short High tone + short delay
Esc [ 1 q
Emit short Low tone + short delay
Esc [ 2 q
Emit long Low tone + short delay
Esc [ 3 q
Emit good read tone
Esc [ 4 q
Emit bad tx tone
Esc [ 5 q
Wait 100 msec
Esc [ 6 q
Turn on the green LED
Esc [ 7 q
Turn off the green LED
Esc [ 8 q
Turn on the red LED
Esc [ 9 q
Turn off the red LED
Esc[0v
Execute vibration for 100 mSec
Esc [ 6 q Esc [ 3 q Esc [ 7 q
Turns on the green LED, emits a good read tone, and turns
off the green LED.
Esc [ 6 q Esc [ 5 q Esc [ 7 q
Turns on the green LED for 100 msec and then turns off the
green LED.
ESC SEQUENCE
ACTION
ESC [ 0 p d d m m y y
Set date to day, month, year
ESC [ 1 p h h m m
Set time to hours, minutes; seconds are automatically set to 00.
