SETUP
12
POWERSCAN™ PD/PM/PBT9600
Symbologies with smaller bars or elements (mil size) should be read closer to the unit.
Symbologies with larger bars or elements (mil size) should be read farther from the unit.
Successful reading is signaled by an audible tone plus a good-read green spot LED indi
-
cator and vibration.
SETTING UP THE POWERSCAN™ PM/PBT9600 READER
Follow the steps below to connect and get your reader up and communicating with its host.
1. Physically mount the Base station and connect it to the Host as described from
.
2. Charge the reader batteries (see
).
3. Link to the Base Station (see
).
4. Select the Interface Type (see
).
5. Configure the Reader starting on
(optional, depends on settings needed).
USING THE POWERSCAN™ PM/PBT9600
The PowerScan™ PM/PBT9600 normally functions by capturing and decoding codes.
Turn on the scanner by pressing the trigger for 2 seconds. When the scanner starts up, it
vibrates. After the vibration, the trigger can be released and the startup phase ends.
The reader is equipped with an internal Motionix™ motion-sensing function which acti
-
vates the aiming system on device motion. The intelligent aiming system indicates the
field of view which should be positioned over the bar code:
Table 2 - Aiming System
NOTE: According to recent modification of Regulation for shipping Li-Ion
based battery packs, the products and their spare battery packs parts are
shipped with a very low residual charge (low state of charge).
Hence the needs:
• that a new product must be fully recharged before starting to use it.
and
• that battery packs of the stocked products PBT/PM9600 and spare
battery pack parts must be periodically recharged. For instance, by
using a BC9600 base station powered up with a 12V Datalogic AC/DC
adapter (cod.8-0935) for at least 30 minutes each 3 months.
MODEL P/N
AIMER PATTERN
PM/PBT9600-SR
PM/PBT9600-HP
