SETUP
18
POWERSCAN™ PD/PM/PBT9600
BASE STATION MODELS
Each base station is composed of a cradle which must be connected to a connection
module, depending on the interface desired and on the IP (water and dust) protection
grade.
The base station and connection module models are listed below.
Base Station Models
BC9600-433 BASE/CHARGER 433MHZ w/o conn. module
BC9600-910 BASE/CHARGER 910MHZ w/o conn. module
BC9630-433 BASE/CHARGER 433MHZ M-INT
BC9630-910 BASE/CHARGER 910MHZ M-INT
BC9631-433 BASE/CHARGER 433MHZ M-INT IP65
BC9631-910 BASE/CHARGER 910MHZ M-INT IP65
BC9680-433 BASE/CHARGER 433MHZ ETH
BC9680-910 BASE/CHARGER 910MHZ ETH
BC9681-433-N100 BASE/CHARGER 433 ETH/PROFINET IP65
BC9681-433-N200 BASE/CHARGER 433 ETH/ETH IP IP65
BC9681-910-N100 BASE/CHARGER 910 ETH/PROFINET IP65
BC9681-910-N200 BASE/CHARGER 910 ETH/ETH IP IP65
BC9600-BT BASE/CHARGER BT NO-INT w/o conn. module
BC9630-BT BASE/CHARGER BT M-INT
BC9631-BT BASE/CHARGER BT M-INT IP65
BC9680-BT BASE/CHARGER BT ETH
BC9681-BT-N100 BASE/CHARGER BT ETH/PROFINET IP65
BC9681-BT-N200 BASE/CHARGER BT ETH/ETH IP IP65
Connection Module Models
CM9630 CONN MOD M-INT
CM9631 CONN MOD M-INT IP65
CM9680 CONN MOD ETH
CM9681-N100 CONN MOD ETH/PROFINET IP65
CM9681-N200 CONN MOD ETH/ETH IP IP65
MOUNTING INSTRUCTIONS
The base station can be either set on or mounted to a flat surface for desktop usage, or
affixed vertically to a wall. Depending on the model, the appropriate connection mod
-
ule is already installed.
Permanent Mounting
For either desktop or wall mounting, the base station can be fastened directly to a flat
surface using screws (not included).
NOTE: When the base station is mounted on vertical surfaces, permanent
mounting is always required.
