Figure 5-61
Please highlight icon
to select the corresponding function. After setting all the setups
please click save button, system goes back to the previous menu.
5.9.4
Abnormality
Abnormality interface is shown as in Figure 5-62.
Event type: There are several options for user such as disk error, no disk, disconnection,
IP conflict and etc.
Alarm output: Please select alarm activation output port (multiple choices).
Latch: Here user can set corresponding delaying time. The value ranges from 10s-300s.
System automatically delays specified seconds in turning off alarm and activated output after
external alarm cancelled.
Show message: system can pop up the message in the local screen to alert user when an
alarm occurs.
Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if user enabled current function.
Send email: System can send out email to alert user when an alarm occurs.
Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.
Figure 5-62
5.10
5.10
5.10
5.10
Network
Network
Network
Network
5.10.1
Basic Setup
Here is for user to input network information. See Figure 5-63.
Summary of Contents for DNA2000 Series
