
5-50.There is three detection types: motion detection, video loss, camera masking.
The video loss has no detection region and sensitivity setup and camera masking has no
detection region setup.
User can see motion detect icon if current channel has enabled motion detect alarm.
User can drag user mouse to set motion detect region without Fn button. Please click OK
button to save current region setup. Right click mouse to exit current interface.
Event type: From the dropdown list user can select motion detection type.
Channel: Select a channel from the dropdown list to set motion detect function.
Enable: Check the box here to enable motion detect function.
Region: Click select button, the interface is shown as in Figure 5-51. Here user can set
motion detection zone. There are 396(PAL)/330(NTSC) small zones. The green zone is
current cursor position. Grey zone is the motion detection zone. Black zone is the disarmed
zone. User can click Fn button to switch between the arm mode and disarm mode. In arm
mode, user can click the direction buttons to move the green rectangle to set the motion
detection zone. After user completed the setup, please click ENTER button to exit current
setup. Do remember click save button to save current setup. If user click ESC button to exit
the region setup interface system will not save user zone setup.
Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.
Period: Click set button, user can see an interface is shown as in Figure 5-53. Here user can
set for business day and non-business day. In Figure 5-53, click set button, user can see an
interface is shown as in Figure 5-54. Here user can set user own setup for business day and
non-business day.
Alarm output: when an alarm occurs, system enables peripheral alarm devices.
Latch: when motion detection complete, system auto delays detecting for a specified time.
The value ranges from 1-300(Unit: second)
Show message: System can pop up a message to alarm user in the local host screen if user
enabled this function.
Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if user enabled current function.
Send email: System can send out email to alert user when an alarm occurs.
Record channel: Select the channel to activate recording function once an alarm occurred.
Please make sure user have set MD record in encode interface(Main
Menu->Setting->Schedule) and schedule record in manual record interface(Main
Menu->Advanced->Manual Record)
PTZ activation: Here user can set PTZ movement when an alarm occurs. System can go to a
preset, when there is an alarm. Click
“
select
”
button, user can see an interface is shown as in
Figure 5-52.
Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
Tour: Here user can enable tour function when an alarm occurs. System one-window tour.
Please go to chapter 5.3.9 Display for tour interval setup.
Snapshot: User can enable this function to snapshoot image when motion detect alarm
occurs.
Please highlight icon
to select the corresponding function. After all the setups please click
save button, system goes back to the previous menu.
Summary of Contents for DNA2000 Series
