Dante DNA2000 Series, Installation And Operation Manual, Page: 48 / 200

Note
Please note the activation snapshot has the higher priority than schedule snapshot. If user have
enabled these two types at the same time, system can activate the activation snapshot when
alarm occurs, and otherwise system just operates the schedule snapshot.
Only the activation snapshot supports this function. The schedule snapshot function may not send
out picture via the email. But user can upload the picture to a FTP.
5.6.4
5.6.4 5.6.4
5.6.4 Motion detect record/snapshot
Motion detect record/snapshot Motion detect record/snapshot
Motion detect record/snapshot
5.6.4.1 Motion detect record
a) From Main menu->Setting->Detect, user can go to the following interface. See Figure
5-39.
Figure 5-39
b) Select motion detect from the event type dropdown list. Select a channel from the
dropdown list and then check the enable button to enable motion detect function.
c) Click Region Select button to set motion detect zone. There are 396(PAL)/330(NTSC)
small zones. The green zone is current cursor position. Grey zone is the motion
detection zone. Black zone is the disarmed zone. User can click Fn button to switch
between the arm mode and disarm mode. In arm mode, user can click the direction
buttons to move the green rectangle to set the motion detection zone. After user
completed the setup, please click ENTER button to exit current setup. Do remember
click save button to save current setup. If user click ESC button to exit the region setup
interface system will not save user zone setup.
d) Set sensitivity. Please note the sixth level has the highest sensitivity.
e) Click Save button to complete motion detect setup.
f) From Main menu->Setting-Schedule. See Figure 5-36
g) Set motion detect record channel, period and the record type shall be motion detect
(MD). Please refer to chapter 5.6.2.
h) Click Copy button to copy current setup to other channel(s).
i) Click OK button to complete motion detect record setup.