Figure 7-107
Figure 7-108
Please refer to the following sheet for detailed information.
Parameter Function
Channel
Select speed dome connected channel.
PTZ Type
There are two options: local/remote.
Please select remote type if user are connecting to the network PTZ.
Protocol
Select the corresponding dome protocol such as PELCOD.
Address
Set corresponding dome address. Default value is 1.
Please note
user setup here shall comply with user dome address; otherwise
user may not control the speed dome.
Baud Rate Select the dome baud rate. Default setup is 9600. Use 2400 with "D"
Data Bit
Default setup is 8. Please set according to the speed dome dial switch
setup.
Stop bit
Default setup is 1. Please set according to the speed dome dial switch
setup.
Please note: Pelco D
uses 2400 Baud Rate
Summary of Contents for DNA2000 Series
