Dante DNA2000 Series, Installation And Operation Manual, Page: 25 / 200

5555 Local Basic Local Basic Local Basic Local Basic Operation Operation Operation Operation
5.1
5.1 5.1
5.1 Boot up and Shutdown
Boot up and Shutdown Boot up and Shutdown
Boot up and Shutdown
5.1.1
Boot up
Before the boot up, please make sure:
The rated input voltage matches the device power on-off button. Please make sure the power
wire connection is OK. Then click the power on-off button.
The external power is DC 12V/AC 100V-240V.
Always use the stable current, if necessary UPS is a best alternative measure.
Please follow the steps listed below to boot up the device.
Connect the device to the monitor and then connect a mouse.
Connect power cable.
Click the power button at the front or rear panel and then boot up the device. After device
booted up, the system is in multiple-channel display mode by default.
5.1.2
Shutdown
Note
When user see corresponding dialogue box “System is shutting down…” Do not click power
on-off button directly.
Do not unplug the power cable or click power on-off button to shutdown device directly when
device is running (especially when it is recording.)
There are three ways for user to log out.
a) Main menu (recommended)
From Main Menu->Shutdown, select shutdown from dropdown list.
Click OK button, user can see device shuts down.
b) From power on-off button on the front panel or remote control
Press the power on-off button on the NVR front panel or remote control for more than 3
seconds to shutdown the device.
c) From power on-off button on the rear panel.
5.2
5.2 5.2
5.2 Startup Wizard
Startup Wizard Startup Wizard
Startup Wizard
After device successfully booted up, it goes to startup wizard.
Click Cancel/Next button, user can see system goes to login interface.
Tips
Check the box Startup button here, system goes to startup wizard again when it boots up the next
time.
Cancel the Startup button, system goes to the login interface directly when it boots up the next
time.