Dante DNA2000 Series, Installation And Operation Manual, Page: 109 / 200

7777 Web Web Web Web Operation Operation Operation Operation
Slight difference may be found on the interface.
User purchased product may not support all the functions listed below.
7.1
7.1 7.1
7.1 General Introduction
General Introduction General Introduction
General Introduction
The device web provides channel monitor menu tree, search, alarm setup, system setup, PTZ
control and monitor window.
7.1.1
Preparation
Before log in, please make sure:
Network connection is right
NVR and PC network setup is right. Please refer to network setup(main
menu->setting->network)
Use order ping ***.***.***.***(* NVR IP address) to check connection is OK or not. Usually the
return TTL value should be less than 255.
Open the IE and then input NVR IP address.
System can automatically download latest web control and the new version can overwrite the
previous one.
If user wants to un-install the web control, please run uninstall webrec2.0.bat . Or user can go
to C:\Program Files\webrec to remove single folder. Please note, before user un-install,
please close all web pages, otherwise the un-installation might result in error.
Current series product supports various browsers such as Safari, firebox browser, Google
browser. Device only support 1-channel monitor on the Apple PC.
About PoE address setup, operation and allocation.
1) Insert PoE
After user insert PoE, device may try to set a corresponding IP address of the Switch network
adapter. First, system tries to set via arp ping. It then uses DHCP if it finds the DHCP is enabled.
After successfully set IP address, system may use Switch to send out broadcast, system thinks
the connection is OK when there is any response. Now system is trying to login the newly found
IPC. Now please check the interface, user can see the corresponding digital channel is active now.
User can see a small PoE icon at the top left corner. User can see the PoE channel, PoE port
information and etc from the connection list of the remote device interface (Chapter 5.3). For the
IP search list, user need to click the IP search to display or refresh.
2) Remove PoE
After user removed PoE, user can see the corresponding digital channel becomes idle (disable).
On the remote device interface, it is removed from the connected list. For the IP search list, user
need to click the IP search to refresh.
3) After user insert PoE, system follows the principles listed below to map channel.
a) If it is user first time to insert PoE, system can map it to the first idle channel. After
map, the channel can memorize the MAC address of the IPC. It is a
<Channel>---<IPC mac>
map. If current channel does not connect to other device,
system can memorize current MAC address, otherwise it can refresh to the newly
added device and memorize the
<PoE port>---<Channel>
.