Channel: Select the current camera channel.
PTZ type: There are two types: local/remote. Please select local mode if user are connect
RS485 cable to connect to the Speed dome (PTZ). Please select remote mode if user are
connecting to the network PTZ camera.
Protocol: Select corresponding PTZ protocol(such as PELCOD)
Address: Default address is 1.
Baud rate: Select corresponding baud rate. Default value is 9600.
PELCO D must use 2400
Data bit: Select corresponding data bits. Default value is 8.
Stop bit: Select corresponding stop bits. Default value is 1.
Parity: There are three options: odd/even/none. Default setup is none.
Figure 5-21
If user are connecting to network PTZ, the PTZ type shall be remote. See Figure 5-22.
Figure 5-22
After completing all the setting please click save button. Right click mouse (click “Fn” Button in
the front panel or click “Fn” key in the remote control). The interface is shown as in Figure
5-23. Please note user can only go to the PTZ control interface when user are in 1-window
display mode.
Summary of Contents for DNA2000 Series
