Dante DNA2000 Series, Installation And Operation Manual, Page: 150 / 200

Figure 7-64
Figure 7-65
Please refer to the following sheet for detailed information.
Parameter Function
Enable User need to check the box to enable motion detection function.
Please select a channel from the dropdown list.
Period Motion detection function becomes activated in the specified
periods. See Figure 7-61.
There are six periods in one day. Please draw a circle to enable
corresponding period.
Click OK button, system goes back to motion detection interface,
please click save button to exit.
Anti-dither System only memorizes one event during the anti-dither period.
The value ranges from 5s to 600s.
Sensitivity
There are six levels. The sixth level has the highest sensitivity.
Region If user select motion detection type, user can click this button to
set motion detection zone. The interface is shown as in Figure
7-62. Here user can set motion detection zone. There are four
zones for user to set. Please select a zone first and then left drag
the mouse to select a zone. The corresponding color zone
displays different detection zone. User can click Fn button to
switch between the arm mode and disarm mode. In arm mode,
user can click the direction buttons to move the green rectangle to
set the motion detection zone. After user completed the setup,
please click ENTER button to exit current setup. Do remember
click save button to save current setup. If user click ESC button to
exit the region setup interface system will not save user zone
setup.
Record
channel System auto activates motion detection channel(s) to record once
an alarm occurs. Please note user need to set motion detect
record period and go to Storage-> Schedule to set current channel
as schedule record.