Ramping
The motor is accelerating/decelerating using the active Up/Down ramp. The reference, a limit
value or a standstill is not yet reached.
Ref. high
In par. 4-55 Warning Reference High a reference high limit is set. The sum of all active references
is above the reference limit.
2
Ref. low
In par. 4-55 Warning Reference High a reference low limit is set. The sum of all active references
is below the reference limit.
Run on ref.
The FC is running in the reference range. The feedback value matches the set reference value.
Run request
(FC 100/200 only)
A start command has been given, but the motor will be stopped until a Run permissive signal is
received via digital input.
Running
The Motor is driven by the FC, the ramping phase is done and the motor revolutions are outside
the "On Reference" range. Occurs when one of the motor speed limits (Par. 4-11 / 4-12 / 4-13 or
4-14) is set, but the maximum reference is outside this range.
Sleep Boost
(FC 100/200 only)
The boost function in parameter 406Boost setpoint is enabled. This function is only possible in
Closed loop operation.
Sleep Mode
(FC 100/200 only)
The energy saving function in parameter 403Sleep mode timer is enabled. This means that at
present the motor has stopped, but that it will restart automatically when required.
Slow down
The output frequency is corrected by the value set in par. 3-12 Catch up/slow Down Value.
1. Slow down was selected as a function for a digital input (parameter group 5-1*). The corresponding
terminal is active.
2. Slow down was activated via serial communication.
Speed high
In par. 4-53 Warning Speed High a value is set. The speed of the motor is above this value.
Speed low
In par. 4-52 Warning Speed Low a value is set. The speed of the motor is below this value.
Standby
[Auto On] The FC starts the motor at a start signal on a digital input (if the parameter is programmed
accordingly) or via serial communication.
8
177R0521-VLT_Aqua_Drive_Training_Handout_BODY.indd 8
4/29/15 2:47 PM