The best way to set parameters using the [Quick Menu] is by following the steps below:
1.
Press [Quick Set-up] for selecting basic motor settings, ramp times, etc.
2.
Press [Function Set-ups] for setting up the required functionality of the adjustable frequency drive - if not already covered by the settings in
[Quick Set-up].
3.
Choose between
General Settings, Open-loop Settings
and
Closed-loop Settings
.
It is recommended to do the set-up in the order listed.
Figure 8.1: Quick menu view.
Par.
Designation
[Units]
0-01
Language
1-20
Motor Power
[kW]
1-22
Motor Voltage
[V]
1-23
Motor Frequency
[Hz]
1-24
Motor Current
[A]
1-25
Motor Nominal Speed
[RPM]
3-41
Ramp 1 Ramp-up Time
[s]
3-42
Ramp 1 Ramp-down Time
[s]
4-11
Motor Speed Low Limit
[RPM]
4-13
Motor Speed High Limit
[RPM]
1-29
Automatic Motor Adaptation (AMA)
Table 8.2: Quick Set-up parameters
If
No Operation
is selected in terminal 27, no connection to +24 V on terminal 27 is necessary to enable start.
If
Coast Inverse
(factory default value) is selected in Terminal 27, a connection to +24 V is necessary to enable start.
NOTE!
For detailed parameter descriptions, please see the following section on
Commonly Used Parameters - Explanations
.
8.1.3 Q1 My Personal Menu
Parameters defined by the user can be stored in Q1 My Personal Menu.
Select
My Personal Menu
to display only the parameters, which have been pre-selected and programmed as personal parameters. For example, a pump
or equipment OEM may have pre-programmed these to be in My Personal Menu during factory commissioning to make on-site commissioning / fine tuning
simpler. These parameters are selected in par. 0-25
My Personal Menu
. Up to 20 different parameters can be defined in this menu.
Q1 My Personal Menu
20-21 Setpoint 1
20-93 PID Proportional Gain
20-94 PID Integral Time
8 How to program the adjustable frequency
drive
VLT
®
AQUA Drive
Instruction Manual
8-2
MG.20.M5.22 - VLT
®
is a registered Danfoss trademark
8