Dakota Ultrasonics
130
Starting delay
The starting
DELAY
, or starting length, is the value displayed on the bottom lower left
side of the display in both
RF
and
RECT
(Rectified) views.
Note:
Once the range is set, it will remain the same for all the views respectively.
The procedures to adjust the
Delay
are outlined below:
Adjusting the Delay using the Hot Menus
1) Press the
key once to activate measure menu items. Press the
key multiple times to move right and the
key multiple times to move left,
until the
DELAY
cell is highlighted.
2) Press the
and
arrow keys multiple times to scroll the highlighted
value.
3)
Alternatively
, press the
key to display the
Digits Edit Box
.
4) Press the
and
arrow keys multiple times to scroll the highlighted
value.
5) Press the
and
arrow keys multiple times to scroll the digit
locations.
6) Repeat steps
4 & 5
until the
DELAY
value is correctly displayed.
7)
Press the
key to return to the measurement screen, or
to cancel
entering the
DELAY
.
The user can also access and adjust the delay from the tabbed menus. However,
this method is more tedious than making the adjustments using the Hot Menus. The
procedure using the tabbed menus is outlined below:
Adjusting the Delay using the Tabbed Menus
Summary of Contents for MiniMax v2.0
Page 2: ......
Page 49: ...MiniMax Bolt Tension Monitor 43 Figure 6 Reflection in a bending bolt...
Page 196: ......
