DAITEM ALARM SYSTEM AND DIALLER, User Manual, Page: 8 / 40

8
2. The keypads transfer information about the control panel status
The keypads can be used to: • operate your system,
• check the status of your system.
IMPORTANT
• Only commands sent from control and information keypads light up the LEDs.
• Only commands issued from a vocal keypad trigger voice messages indicating possible alarms, faults and the status of exits.
Commands
sent to:
Command Indications
& messages at the information
& command keypad
Message issued by vocal keypad
with tag reader
LED status Buzzer
A control panel
Disarm
keyfob 1.5 s
G
long beep
“Bip, Off” or “Bip, Fault System”
OFF/Disarm
with alarm memory
G G G
3 short beeps
Arm
keyfob 1.5 s
R
long beep
“Bip, Armed”
ON/Arm with fault keyfob 1.5 s
R
3 short beeps
Armed partial 1 keyfob 1.5 s
R
long beep
“Bip, Armed Partial 1”
Armed partial 2
keyfob 1.5 s
R
long beep “Bip, Armed Partial 2”
ON Partial 1, with a fault keyfob 1.5 s
R
3 short beeps
ON Partial 2, with a fault keyfob 1.5 s
R
3 short beeps
Arm group X
keyfob 1.5 s
R
long beep
“Bip, Armed Group X
ON Group X with an anomaly keyfob 1.5 s
R
3 short beeps
ON blocked (1)
R R R
3 short beeps
Disarm group X
keyfob 1.5 s
G
long beep
Bip, Off Group X”
OFF group X
with alarm memory
G G G
3 short beeps
Arm in presence mode “Bip, Armed Presence”
Alarms memorised “Bip, Off, Alarm System”
Faults memorised
“Bip, Armed, Fault System”
or “Bip, Off, Fault System”
Exits open
keyfob 1.5 s
R
3 short beeps
“Bip, Armed, Exit Opened”
Switching receiver,
remote control unit
Transmit a home automation
command (light, relay, etc.)
keyfob 1.5 s
G
Switch to test mode
“Bip, Test mode”
Switch to installation mode “Bip, Installation mode”
Switch to user mode “Bip, Off”
System status query
“Bip, system status, Armed”
“Bip, System_status, Armed Partial 1 or 2”
“Bip, System_status, Off”
“Bip, System_status, Armed Group X”
“Bip, System_status, Armed Presence”
“Bip, System_status,...Fault System”
“Bip, System_status,...Exit Opened”
“Bip, System_status,...Exit Inhibited”
(1) A stopped ON/Arming operation means the system has been unable
to complete Arming due to a system fault.
X: group 1 to 8 depending on type of control panel
: green LED
: red LED
G
R