DAITEM ALARM SYSTEM AND DIALLER, User Manual, Page: 29 / 40

29
4.1.2 Procedure for remote operation over the phone
1
2
3 4
5
6
7
8
9
0
*


Call your dialler using
a DTMF tone dial or
mobile phone
Your dialler confirms the
code is correct by issuing
a long beep and then
announcing the system
status and any faults
and/or alarms (only if the
dialler is connected to a
control panel).
ONLY VIA PSTN: if the telephone is connected to an automatic answering device (answering machine, fax, etc.) or an operator
answering service, apply the two-calls-in-a-row procedure:
1. enter the dialler telephone number a first time,
2. let the phone ring twice and then hang up,
3. in the next 15 to 20 seconds, enter the dialler number a second time and the dialler will automatically pick up the call on the 1st ring,
4. access the voice menu for remote control operation.
master code (1)
“Press * then
enter the
access code”
“Beeep,
system status”
Result
What to press on handset unit keypad
IMPORTANT: for each voice menu, you must wait until the end
of the messages issued by the control panel before entering
the desired command number.
control panel disarmed
á
system status announced
á
“To modify system
status press ”
1
“To consult system
status press ”
“To disarm press ” (2)
“To arm press ” (2)
1
“For menu press ” (2)
“For system
command press ”
3
“To modify call
number press ”
2
“Voice menu
proposed”
command sent
(see summary table
of remote control
command codes
on previous page)
á
command n°
“Enter command”
ƒ
return to main menu
á
“For menu press ”
ƒ
ƒ
ƒ
ƒ
ƒ
recorded n° announced
á
“Press n° then ”
“To consult press ”
new number
recorded announced
á
“To modify press ” (3)
1
return to main menu
á
“For menu press ”
control panel armed
á
return to main menu
á
(1) If 5 wrong master codes are entered in less than 5 minutes, the dialler hangs up and remote control operation is disabled for 5 minutes.
(2) If the control panel does not respond, you will hear the message “Bip, Radio Fault”.
(3) Only numbers can be remotely modified and not the protocols (voice, SMS) and associated options.
(4) Function only available with GSM media.
Your dialler picks up
the call
• If the user does not press a key during any of the menus listed above, the dialler repeats the menu every 5 s (5 times max)
before automatically hanging up.
• Press on your telephone handset unit keypad to return to the initial voice menu at any time.
PSTN
main
s-po
were
d
GPR
S
“To listen in press ”
4
Listen-in is active
á
Options during Listen-in:
speak-
out/talk-back
activated
7
listen-in
activated
8
intercom
activated
9
intercom stopped
and return to main
menu