DAITEM ALARM SYSTEM AND DIALLER, User Manual, Page: 32 / 40

32
5. Testing calls to your correspondents
All programmed numbers can be tested separately. The test procedure is identical whatever the transmission media. For
voice calls and SMS, the message transmitted is “Dialler identification n°, test call”. For calls to a remote monitoring centre,
the message transmitted is encoded according to FSK200 Bauds, Contact ID and ViewCom IP protocols and the media
used.
1. Put the dialler in test mode:
2. To trigger a test call, enter:
3. Wait until the end of the test call and then check the alarm has been telephone transmitted to the programmed
correspondents.
4. Switch the dialler to user mode:
PSTN
GSM
/
GPR
S
ETHE
RNE
T
(ADS
L)
• First let your correspondents know you are going to perform a test call.
• We advise you to systematically perform a test call every time you record a new number.
1: 1 st number
2: 2 nd number
3: 3
rd
number
4: 1 st number
5: 2 nd number
master code
master code
master code
6: 1 st number
7: 2 nd number
8: 3
rd
number
9: system correspondent number
(GSM/GPRS only)
}
Cycle 1
}
Cycle 3
}
Cycle 2
DIALLER
“bip”