User's Manual
241
Table 4-37
Parameter
Description
Enable
Click to enable or disable the face detection.
Rule
Click
Setting
to draw areas to filter the target.
You can configure two filtering targets (maximum size and
minimum size). When the target is smaller than the minimum size
or larger than the maximum size, no alarms will be activated. The
maximum size should be larger than the minimum size. Left click
to drag the four angles to adjust the size.
Schedule
Configure the period and in the set time range, the corresponding
configuration item will be linked to start the alarm.
Alarm-out Port
The alarm device (such as lights, sirens, etc.) is connected to the
alarm output port. When an alarm occurs, the NVR device
transmits the alarm information to the alarm device.
Post-Alarm
When the alarm ends, the alarm extended for a period of time. The
time range is from 0 seconds to 300 seconds.
Report Alarm
Select the check box. When an alarm occurs, the NVR device
uploads an alarm signal to the network (including the alarm
center).
●
This function is for some series products only.
●
You need to set the alarm center first. For details, see "4.11.14
Alarm Center".
Send Email
Select the check box. When an alarm occurs, the NVR device sends
an email to the set mailbox to notify the user.
You need to set the email first. For details, see "4.11.11 Email".
Record Channel
Select the check box and select the needed recording channel
(support multiple choices). When an alarm occurs, the NVR device
activates the channel for recording.
You need to enable intelligent recording and auto recording first.
For details, see "4.1.4.6 Schedule".
PTZ Linkage
Select the check box and click
Setting
to select the channel and
PTZ action. When an alarm occurs, the NVR device associates the
channel to perform the corresponding PTZ action. For example,
activate the PTZ in channel one to turn to the preset point X.
●
Tripwire alarm supports to activate PTZ preset point only.
●
You need to set the corresponding PTZ actions first, see "4.4.4
Calling PTZ Functions".
Post-Record
At the end of the alarm, the recording extends for a period of time.
The time range is from 10 seconds to 300 seconds.
Summary of Contents for NVR41-4KS2 Series
