Daewoo Bus BS Series, Owner'S Manual, Page: 155 / 260

• •
SET : The switch is used to apply
the changed setting such as the
interval time, the contact time, and
the count.
• •
MODE : This switch is used to move
between options. It moves in the
order of INTERVAL TIME
→
CONTACT TIME → COUNT →
VOLTAGE → ERROR CODE →
INTERVAL TIME.
• •
MANUAL : The switch is used when
operating the motor manually. Initial
activation of the switch activates the
device for a set contact time.
Therefore, it allows manually
application of the lubrication to each
point, and is especially effective
during a rain or after a car wash.
• •
TEST : The switch is used to test the
lubrication by repeating on/off after
reducing the interval time and the
time to a specific cycle. Activating the
TEST switch activates the device for
15 seconds, deactivates it for 15
seconds, activates it again for 15
seconds, and repeats this cycle
continuously. Therefore, return the
switch to its original position after the
testing is completed.
• •▲
: The switch increases a value.
Holding the switch down results in a
faster increase in the value due to
the automatic repeat function.
• •▼
: The switch decreases a value.
Holding the switch down ewsults in a
faster decrease in the value due to
the automatic repeat function.
6-13
VEHICLE INSPECTION AND MAINTENANCE
Using the Automatic Lubrication Device Controller (KUMHO, VOGEL)
REFERENCE
The controller is installed in the fuse
box in the luggage room.
OM-B213