Daedong KIOTI PX1053, Manual

Page: 207 / 256

7
MainTenance
7
-
23
1. place a suitable container below
the fuel filter assembly to retain
spilled fuel oil.
2. Thoroughly clean the outside sur-
faces of the fuel filter assembly.
open the drain tap at the bottom
of the filter casing to drain the fuel
from the filter.
3. use a strap wrench to loosen the
filter casing. remove the casing
and element from the fuel filter
head.
REPLACING FUEL FILTER(S)
(1) Drain Tap
A40O729b
4. To remove the filter element from the
casing; press down on the filter ele-
ment, against the spring pressure, and
rotate the element to counterclockwise
to release it from the filter casing.
5. put the new filter element inside
the casing and press the element
down against the spring pressure.
rotate the element to clockwise to
lock the element into the casing.
6. fit a new seal to the casing and
lightly lubricate the seal face with
clean fuel oil.
(1) filter element (2) Thread
(3) seal (4) filter casing
7. check that the thread on the inside
of the element is not damaged.
8. Fit the filter assembly to the fuel
filter head and tighten by hand
until the filter assembly contacts
the filter head. Tighten the as-
sembly a further 1/8 of a turn by
hand. Do not use a strap wrench.
9. close the drain tap and remove
the container.
The pre-filter canister and
main filter elements must be
renewed at the same time.
Do not allow dirt to enter the
fuel system. Before a connec-
tion is disconnected, clean the
area around the connection.
After a component has been
disconnected, fit a suitable
cover to all open connections.
•
•
CAUTION
TG2O717A
TG120-수출향-US-07.indd 23 2017-10-26 오후 1:20:47