Daedong KIOTI PX1053, Manual

Page: 159 / 256

5
opERATIoN
5
-
1
3. To keep the plowing depth shallow,
put the draft control lever to the
rear(shallow) position. The plow-
ing depth tends to become deeper
naturally by outer conditions. As
the plowing depth increases the
applied load also increases. plac-
ing the draft control lever to the
"Shallow" position, plowing depth is
maintained as shallow because the
reaction force is transferred to the
internal system via the top link and
the lifting arm is automatically lifted.
4. When using an implement which
requires no draft function, such as a
rotary tiller and mower, use the high-
est hole on the top link and put the
draft control lever in any position.
5. However, if the draft control lever
is pushed forward to its end, the
lowest position of the lifting arm
can be lowered a little. on the oth-
er hand, if the lever is pulled back
to its end, the highest position of
the lifting arm can be raised a little.
If the lifting arm is properly
operated but abnormal noise
is still heard, the hydraulic
system may be malfunction-
ing. In this case, let the engine
idle for 10 to 15 minutes and
then resume functions. If the
problem is still present, con-
tact your local KIOTI Dealer.
The implement may shake up
and down as the draft sensor
is under impact when the trac-
tor is passing over irregular
ground with the middle or low-
est top link hole selected. In
this case, put the draft control
lever to the "Deep" position
to decrease the sensitivity of
the draft function or select the
highest top link hole.
•
•
CAUTION
If the tractor has been stored
for a long period of time or
the transmission fluid is just
changed, abnormal noise may
be heard and the hydraulic
lifting arm may be inoperable
temporarily. In this case, let
the engine idle for 3 to 4 min-
utes.
•
CAUTION
TG120-수출향-US-05.indd 21 2017-09-14 오후 6:57:51