DAB E.sybox 50, Instruction For Installation And Maintenance

Page: 106 / 934

ENGLISH
GB
103
In the DAB catalogue there is a Kit for the integrated creation of a booster
set of 2 systems. The booster made with the DAB kit appears as in Fig.21
9.4.12 - Wireless Control
As described in par. 9.4.3, the device can be connected to other devices
by means of the proprietary wireless channel. There is therefore the pos
-
sibility of controlling particular operations of the system through signals
received in remote mode: for example, depending on a tank level supplied
by a float it is possible to order it to be filled; with the signal arriving from
a timer it is possible to vary the setpoint from SP to P1 to supply irrigation;
These signals entering or leaving the system are managed by a control
unit that can be bought separately from the DAB catalogue.
Figura 21
10. MAINTENANCE
Disconnect the power supply before starting any work on the sys
-
tem.
The system requires no routine maintenance operations.
However, below are the instructions for performing the special mainte
-
nance operations that may be necessary in particular cases (e.g. emptying
the system to put it away during a period of inactivity).
10.1 - Accessory tool
With the product DAB supplies an accessory tool that is useful for carrying
out the operations contemplated on the system during installation and any
special maintenance operations.
The tool is housed in the technical compartment. It is composed of 3 keys:
1 - metal key with a hexagonal section (Fig.22 – 1);
2 - flat plastic key (Fig.22 – 2);
3 - cylindrical plastic key (Fig.22 – 3).
Key “1” is in turn inserted in the end “D” of key “3”. At the first use you
must separate the 2 plastic keys “2” and ”3”, which are supplied joined by
a bridge (Fig.22 – A):
break the bridge “A”, taking care to remove the cutting residue
from the 2 keys so as not to leave any sharp bits that could cause
injuries.