4 Web-based Switch Configuration
D-Link DGS-2000 Series Ethernet Switch User Manual
4
4
3
3
Facility:
Specifies an application from which system logs are sent to the remote server. Only one facility can
be assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are
up to eight facilities can be assigned (Local 0 ~ Local 7).
UDP Port:
Specifies the UDP port to which the server logs are sent. The possible range is
6000 – 65535
,
and the default value is
514
.
Status:
Specifies the status is enable or disable
System > Time Profile
The Time Profile page allows users to configure the time profile settings of the device.
Figure 4.45 – System > Time Profile Settings
Range Name:
Specifies the profile name for the time profile to be configured.
Date:
Select Date and specifies the
From Day
and
To Day
of the time profile.
Hours (HH MM):
Specifies the
Start Time
and
End Time.
Weekdays:
Specifies the work day for the time profile. Or tick
Select All Days
to select all days for the time
profile.
Click
Apply
to create a new time profile or click
Delete
to delete a time profile from the table.
NOTE:
The time must be set after current time,
otherwise it will take effect on the next cycle time.
System > Power Saving
The Power Saving mode feature reduces power consumption automatically when the RJ-45 port is link down
or the connected devices are turned off. Less power will be consumed also when the short cable is used
(less than 20 meters).
By reducing power consumption, less heat is produced, resulting in extended product life and lower
operating costs. By default, the Cable Length Detection and Link Status Detection are enabled. Click
Apply
to make the change effective.
Figure 4.46 – System > Power Saving
