4 Web-based Switch Configuration
D-Link DGS-2000 Series Ethernet Switch User Manual
4
4
2
2
Interval (1-2147483647 sec):
The time in seconds between notifications.
History Size (1-500):
The maximum number of entries listed in the history log used for notification. Up to
500
entries can be specified.
Click
Apply
to make the configurations take effect.
To change MAC notification settings for a port or group of ports on the Switch, configure the following
parameters. , then click the
Apply
button.
From Port / To Port:
Select a port or group of ports to enable for MAC notification using the pull-down
menus.
State:
Enable MAC Notification for the ports selected using the pull-down menu.
System > System Log Configuration > System Log Settings
System Logs record and manage events, as well as report errors and informational messages. Message
severity determines a set of event message will be sent. Click
Enable
so user can start to configure the
related settings of remote system log server, then press
Apply
for the changes to take effect.
Figure 4.43 – System > System Log Configuration > System Log Settings
Save Mode:
Use this drop-down menu to choose the method that will trigger a log entry. User can choose
between
On Demand
,
Time Interaval
and
Log Trigger.
Time Interval:
Enter a time interval, in seconds, for which user would like a log entry to be made.
System > System Log Configuration > System Log Server
The user can send Syslog messages to up to four designated servers using the
System Log Server
. It
supports maximum 500 system log entries. To set the System Log Server configuration, click
Apply
.
Figure 4.44 - System > System Log Configuration > System Log Server
Server ID:
Specifies the Server ID. The field range is 1-4.
Severity:
Specifies the minimum severity from which warning messages are sent to the server. There are
three levels. When a severity level is selected, all severity level choices above the selection are selected
automatically. The possible levels are:
Warning -
The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Informational -
Provides device information.
All -
Displays all levels of system logs.
Server IPv4 Address:
Specifies the IPv4 address of the system log server.
Server IPv6 Address:
Specifies the IPv6 address of the system log server.
