4 Configuration
DGS-1210 series Metro Ethernet Managed Switch User Manual
26
.
Figure 4.15 – System > Firmware Information
System > Serial Port Settings
The Serial Port Settings allows the user to adjust the Baud Rate and the Auto Logout values.
.
Figure 4.16 – System > Firmware Information
Baud Rate:
Specify the baud rate for the serial port on the Switch. There are four possible baud rates to
choose from, 9600, 19200, 38400 and 115200. For a connection to the Switch using the console port, the
baud rate must be set to 9600, which is the default setting.
Auto Logout:
Select the logout time used for the console interface. This automatically logs the user out after
an idle period of time, as defined. Choose from the following options: 2, 5, 10, 15 minutes or Never. The
default setting is 10 minutes.
Date Bits:
Display the date bits used for the serial port connection.
Parity Bits:
Display the parity bits used for the serial port connection.
Stop Bits:
Display the stop bits used for the serial port connection.
Click
Apply
to make the configurations take effect.
System > IP Interface
The IP Interface page allow user to configure the IPv6 system settings.
Summary of Contents for DGS-1210 Series
Page 159: ...140 ...
