4 Configuration
DGS-1210 series Metro Ethernet Managed Switch User Manual
1
1
3
3
7
7
Figure 4.212 – PoE > PoE Port Settings
From Port/To Port:
Specifies the PoE function of a port or ports.
State:
Select “Enabled” or “Disabled” to configure PoE function for designated port(s). Default is
Enabled
.
Time Range:
Select the PoE time profile configured from Time-Based PoE > Time Range Settings to enable
the time-based PoE function on designated port(s). Default setting is
N/A
.
Priority:
Configure the power supply priority as “
Low
”, “
Normal
”, or “
High
” on designated port(s). Default is
Normal
.
Delay Power Detect:
Configure the delay power detection. Default is Disabled. This switch conforms to
IEEE 802.3af and 802.3at standards. The IEEE PoE standard requires a switch to shut off power to a port if
the power draw is less than 10mA within a 400ms time interval. To support some non-standard devices that
may take longer, you may enable this feature to extend the time interval to 500ms. If the PD is still not
powering on, please contact the vendor of your device for support.
Power Limit:
This function allows you to manually set the port power current limitation to be given to the PD.
To protect the DGS-1210-28P/ME and the connected devices, the power limit function will disable the PoE
function of the port when the power is overloaded. Select from "
Class 1
", "
Class 2
", "
Class 3
",
“Class 4”,
User Define
and "
Auto
" for the power limit. "
Auto
" will negotiate and follow the classification from the PD
power current based on the 802.3at standard. Select
User Define
then input the power budget (from 1 to
30W) to manually assign an upper limit of port power budget on designated port(s).
Click
Apply
to make the configurations take effect or click
Refresh
to redisplay the table.
Note: For the PoE Port Settings table, if the
classification was shown as “Legacy PD”, it will be
classified to non-AF PD or Legacy PD.
Note: The ports 1-4 are capable of feeding power
up to 30 watts to devices with the LLDP-Med
function is enabled of the connected PD. Or the
ports can only feeding power up to 15.4 watts.
Summary of Contents for DGS-1210 Series
Page 159: ...140 ...
