Cyclades AlterPath OnBoard, Administrator'S Manual

Page: 363 / 460

Appendix A: Advanced Device Configuration 327
Understanding How the OnBoard Manages Communications With Devices
If “Test” is selected, after the administrator selects a template, a list of
devices that use the selected template appears, like the list shown in the
following screen example
After the administrator selects a template and a device to test, a list of
commands to test displays like the one shown in the following screen
example.
Not all listed commands are supported on every device. If you select an
unsupported command, an error message displays that lists the supported
commands.
The first time you select any action to test, you are prompted to enter a
username and password. If local authentication is specified for the device,
enter the username and password that you entered to access the OnBoard. If
another authentication method is specified for the device, use the appropriate
username and password for the specified authentication method. The test
command uses the same authentication and authorization processes that the
OnBoard uses in its normal operation, as explained in under Chapter 1,
Select Service Processor to test against:
-rack1_ibm_e360_rsa_II
rack2_ibm_e360_rsa_II
Select a test to perform:
-Login and Native Command Interface
Console Access
Power On
Power Status
Power Cycle
Reset
Power Off
System Event Log
Clear Event Log
Retrieve Sensors
Test All
Exit