CTS FOS-3124 SERIES, User Manual

Page: 57 / 223

57
Switch(config-if-1-3)# ip igmp static-multicast-ip
224.10.0.5 vlan 50 Create a static multicast IP to VLAN
entry.
2.6.11 LLDP Command
LLDP stands for Link Layer Discovery Protocol and runs over data link layer. It is used for
network devices to send information about themselves to other directly connected devices
on the network. By using LLDP, two devices running different network layer protocols can
learn information about each other. A set of attributes are used to discover neighbor devices.
These attributes contains type, length, and value descriptions and are referred to TLVs.
Details such as port description, system name, system description, system capabilities, and
management address can be sent and received on this Managed Switch. Use Spacebar to
select “ON” if you want to receive and send the TLV.
LLDP command Parameter Description
Switch(config)# lldp
hold-time [1-3600] [1-3600] Specify the amount of time in seconds. A receiving
device will keep the information sent by your
device for a period of time you specify here before
discarding it. The allowable hold-time value is
between 1 and 3600 seconds.
Switch(config)# lldp
initiated-delay [0-300]
[0-300] Specify a period of time the Managed Switch will
wait before the initial LLDP packet is sent. The
allowable initiated-delay value is between 0 and
300 seconds.
Switch(config)# lldp
interval [1-180] [1-180] Specify the time interval for updated LLDP packets
to be sent. The allowable interval value is between
1 and 180 seconds.
Switch(config)# lldp
packets [1-16] [1-16] Specify the amount of packets that are sent in
each discovery. The allowable packet value is
between 1 and 16 seconds.
Switch(config)# lldp tlv-
select capability Enable Capability attribute to be sent.
Switch(config)# lldp tlv-
select management-
address Enable Management Address attribute to be sent.
Switch(config)# lldp tlv-
select port-description Enable Port Description attribute to be sent.
Switch(config)# lldp tlv-
select system-
description Enable System Description attribute to be sent.
Switch(config)# lldp tlv-
select system-name Enable System Name attribute to be sent.
No command
Switch(config)# no lldp hold-time Reset the hold-time value back to the default
setting.
Switch(config)# no lldp initiated-delay Reset the initiated-delay value back to the default
setting.
Switch(config)# no lldp interval Reset the interval value back to the default setting.