CTS FOS-3124 SERIES, User Manual

Page: 45 / 223

45
2.
Use “Interface” command to configure link aggregation groups dynamically (LACP).
Channel-group & Interface
command
Parameter Description
Switch(config)# interface [port_list] [port_list] Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)#
channel-group lacp
Enable LACP on the selected
interfaces.
Switch(config-if-PORT-PORT)#
channel-group lacp key [0-255] [0-255] Specify a key to the selected
interfaces.
Switch(config-if-PORT-PORT)#
channel-group lacp type [active] [active] Specify the selected interfaces to
active LACP type.
No command
Switch(config-if-PORT-PORT)# no
channel-group lacp Disable LACP on the selected
interfaces.
Switch(config-if-PORT-PORT)# no
channel-group lacp key Reset the key value of the selected
interfaces to the factory default.
Switch(config-if-PORT-PORT)# no
channel-group lacp type Reset the LACP type of the selected
interfaces to the factory default
(passive mode).
Show command
Switch(config)# show channel-
group lacp
Show or verify each interface
‟s LACP
settings including current mode, key
value and LACP type.
Switch(config)# show channel-
group lacp [port_list] [port_list] Show or verify the selected interfaces
‟
LACP settings.
Switch(config)# show channel-
group lacp status Show or verify each interface
‟s current
LACP status.
Switch(config)# show channel-
group lacp status [port_list] [port_list] Show or verify the selected interfaces
‟
current LACP status.
Switch(config)# show channel-
group lacp statistics Show or verify each interface
‟s current
LACP traffic statistics.
Switch(config)# show channel-
group lacp statistics [port_list] [port_list] Show or verify the selected interfaces
‟
current LACP statistics.
Switch(config)# show channel-
group lacp statistics clear Clear all LACP statistics.
Channel-group & interface command example
Switch(config)# interface 1-3 Enter port 1 to port
3‟s interface mode.
Switch(config-if-1-3)# channel-group lacp Enable LACP on the selected
interfaces.
Switch(config-if-1-3)# channel-group lacp key 10 Set a key value
“10” to the selected
interfaces.
Switch(config-if-1-3)# channel-group lacp type
active Set the selected interfaces to active
LACP type.