49
“authorized”:
This forces the
Managed Switch to grant access to all
clients, both 802.1X-aware and
802.1x-unaware. No authentication
exchange is required. By default, all
ports are set to “authorized”.
Switch(config-if-PORT-PORT)#
dot1x reauthenticate
Re-authenticate the selected
interfaces.
No command
Switch(config)# interface [port_list]
[port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)# no
dot1x port-control
Reset the selected interfaces
‟ 802.1x
state to the factory default (authorized
state).
Show command
Switch(config)# show dot1x
Show or verify 802.1x settings.
Switch(config)# show dot1x
interface
Show or verify each interface
‟s 802.1x
settings including port status and
authentication status.
Switch(config)# show dot1x
interface [port_list]
[port_list]
Show or verify the selected interfaces
‟
802.1x settings including port status
and authentication status.
Switch(config)# show dot1x
statistics
Show or verify 802.1x statistics.
Switch(config)# show dot1x
statistics [port_list]
[port_list]
Show or verify the selected interfaces
‟
statistics.
Switch(config)# show dot1x status
Show or verify 802.1x status.
Switch(config)# show dot1x status
[port_list]
[port_list]
Show or verify the selected interfaces
‟
802.1x status.
Dot1x & interface command example
Switch(config)# interface 1-3
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-1-3)# dot1x port-control auto
Set the selected ports to
“auto” state.
Switch(config-if-1-3)# dot1x reauthenticate
Re-authenticate the selected
interfaces immediately.
Summary of Contents for FOS-3124 SERIES
Page 202: ...202 Restart DHCP service ...
