Coral Telecom DX2000XL, User Programming Manual

Page: 116 / 141

User & Programming Manual
DX2000 XL – Hotel Version
116
Concessional rates. Hence in the fifth row, all the entries from column 1 to column 10 will be
1800, which corresponds to 180 seconds (i.e) 3 minutes.
If it is required to change the pulse rate of a cellular call as 5 minutes then the entries in
columns 1 to 10 of fifth row must be 3000.
If zone 11 & 12 are not used, then there is no need to enter any value in these columns. The
default entries in these columns are 1800.
The 13
th
column of row 5 is used for enabling or disabling holiday rates. A 1 in this column
enables holiday rates for cellular calls & a 0 disables holiday rates. The default entry in this
column is 0 (i.e) holiday rate is disabled for cellular calls.
The 14
th
column is used for entering the pulse rate for holiday. The default entry is 1800.
The 15
th
column is used for entering the charge of one unit. The default entry is 200
corresponding to Rs. 2 for one unit of cellular call. For example if it is required to charge Rs.
5 for one unit of cellular call, the entry in this column must be 500.
16
th
column is used for entering the service charge for one cellular call. Default entry is 0.
Till now we have seen the default rate table. These tables will be used only if there is no
match found in the CODE TABLE. Starting from row 6 and upto row 25, there are general
purpose rate tables. The default entries made in these rows are given in the attached sheet.
The default entries are made keeping in view the various new STD & ISD rates currently
implemented by DOT. So in most of the cases, it may not be required to alter the rate table.
In the default entries, rows 6 to 9 contain the various ISD pulse rate; rows 10 to 13 contain
the various STD pulse rate; rows 14 & 15 contain the inter dialing rates.
Any entry in the COST TABLE can be altered including the various time zones. There is no
fixed criteria as full rate, half rate, one third rate etc.. You can enter any pulse rate in any
column. As explained above, you are actually entering the duration of one unit in each time
zone. System will not check for the validity of the pulse rate entered by you in any column.
CODE TABLE
This table is used for entering the various STD / ISD codes. It is also possible to enter local
numbers in the cost table. This will be used for implementing the different charges for Inter
dialing numbers.
For example if it is required to have the charge calculations corresponding to row 10 for STD
code 011, the entry in the CODE TABLE must be 10 for the code 01100.
Similarly, the entries must be made in the code table for each code. If no matches are found
in the CODE TABLE for any code, then the default entries in the rows 2 to 5 in the COST
TABLE will be used.