Coral Telecom DX2000XL, User Programming Manual

Page: 105 / 141

User & Programming Manual
DX2000 XL – Hotel Version
105
To enable the same, command is,
56 + 00 + 125 + 129 + 000 - To enable the trunk CLI transfer
56 + 00 + 125 + 001 + 000 - To disable the trunk CLI transfer
Default: Disabled
CLI on SLT
DX can extend the CLI on SLT also. To enable the same on SLT, following programming is
required.
33 Ext 3 - To enable the CLI on a SLT
33 Ext 2 - To disable the CLI on a SLT
Further, while regenerating the CLI on SLT, DX generates the CLI between first two rings.
With SMD based Line cards, command will be
56 + 00 + 051 + 001 + 00
However DX can generate the CLI before the ring also. For the same, command will be,
56 + 00 + 051 + 000 + 00
Important : With SMD line cards, CLI is generated between ring while with DIP type line
cards, CLI is generated before ring.
Trunk & extension grouping for CO access
This command is used for grouping of the extensions for giving them the right of some
particular trunks for making outgoing calls. Following is the concept for trunk-extension
grouping for trunk accessing.
Pls. refer the below diagram. There are total 10 groups for extensions & trunks. As per this
diagram, extension of group 0 can access all the trunk groups. Extension group 1 can access
the trunk group 0 & trunk group 1. Extension group 2 can access the trunk group 0 & 2 & so
on.
An extension can be defined only in one extension group while a trunk can be defined in
multiple trunk groups. If an extension is defined in another extension group, that extension
will be removed from the existing extension group. If a trunk is defined in another trunk
group that will be defined in that group as well as existing group.