Controls WIZARD 2 50-C13A0X, Instruction Manual

Page: 22 / 120

Manuale di Istruzione
Instruction Manual
23/08/2018 Rev.1 EN
20
WARNING:
The CALIBRATION menu is reserved to the authorised service personnel. CONTROLS
will not be responsible for any damage caused by improper setting of these parameters.
Warranty will be void if this menu is used by unauthorised personnel.
WARNING:
Be careful and use proper personal protection devices (e.g. gloves, protective shoes)
while loading/unloading samples from the test frame, due to the sample weight and sharp
surfaces.
WARNING:
Be careful and use proper personal protection devices (e.g. gloves, protective shoes)
while handling distance pieces and platens of the frame due to their weight.
WARNING:
Always close the front door and place the rear guard on the frame while executing the
tests. Also use proper personal protection devices (e.g. glasses) in order to avoid injures
due to fragments of samples ejected during the test (e.g. in case of test on explosive
samples).
WARNING:
Although the maximum speed of the loading piston of the frame is very low (max. 40
mm/min), to avoid injures during the compression phase, always close the front door and
place the rear guard while executing the tests. Also avoid putting hands/fingers in the gap
between the sample and the upper platen.
WARNING:
Before releasing the EMERGENCY BUTTON make sure that the lever of the hydraulic
ON/OFF valve is in the lower positions (discharge position).
WARNING:
Before turning the equipment OFF make sure that the lever of the hydraulic ON/OFF
valve is in the lower positions (discharge position).
WARNING:
Failing to perform the recommended maintenance actions or maintenance performed by
unauthorized people can void the warranty.
CONTROLS will not be responsible for maintenance and service actions performed by
unauthorized people.
WARNING:
Before opening/removing the covers, disconnect the mains supply to the device and wait
at least 5 minutes.