Controls WIZARD 2 50-C13A0X, Instruction Manual

Page: 86 / 120

Manuale di Istruzione
Instruction Manual
23/08/2018 Rev.1 EN
84
5.1 Operator’s preventive maintenance
The inspections made directly by the operator are the following:
Action Who When
Check to ensure that there is no
external damage to the equipment,
which could jeopardise the safety of
use Operator Before every working session
Clean and dry platens, distance
piece and ram of the frame from the
sample debris Operator At the end of each working
session
General inspection Operator Weekly
Check the status of the hydraulic
tubes against leakages and damages Operator Weekly
Check status of the safety devices:
EMERGENCY BUTTON , max.
pressure valve, piston over travel
switch and relevant cable on the
frame, front door and rear
transparent guard on the frame
(refer to chapter 5.1.1 for their
identification)
Operator Weekly
Check status and functioning of the
operator's commands Operator Weekly
Check the level of the oil in the
tank (see chapter 5.1.2) Operator Monthly
Check that all label and rating
plates are intact and properly
attached Operator Monthly
NOTE:
Previous table indicates also the maintenance actions to be performed on the frames
normally connected to the control console.