Controls WIZARD 2 50-C13A0X, Instruction Manual

Page: 14 / 120

Manuale di Istruzione
Instruction Manual
23/08/2018 Rev.1 EN
12
1.4 Intended use and improper use
The 50-C92AXX WIZARD 2 Multipurpose Compression and Flexural testers can only
be used to perform building material tests according to the relevant international
standards.
The unit is designed to be operated by one operator that has to install the necessary
distance pieces, load-unload the sample from the frame, input the test parameters and start
the test.
During normal operation, the working area of the equipment is the front side where the
operator’s controls and the display are located.
The operator is responsible of starting-up the equipment, performing the test sequence,
shutting down the equipment and eventually stopping it in case any emergency conditions
are met.
The operator must be trained on the correct use of the machine and the relative safety
aspects of its use.
The machine should be used following the procedures described in this manual.
Never use the machine for reasons other than those for which it was designed and
manufactured. Any other use of the machine is to be considered improper, not foreseen
and hence dangerous.
CONTROLS will not be responsible for improper use of the machine.