2 System Reference
PT-E731, PT-E731S, PT-E731H, PT-E731HS User’s Manual
13
2.
System Reference
Specification
Table 2.1. Functional Specification < 1 / 2 >
Model PT-E731
PT-E731H
PT-E731S
PT-E731HS
OS
Windows XP Embedded SP2 (recommend), Windows XP Professional
CPU
Intel Celeron M ULV 1GHz
Memory 512MB
Resume Function(*1)
Resume function (Continue/Standby mode can be selected when power
failure is detected.)
[Continue mode]: System keeps operating for 10 minutes during the
power failure. (Backlight becomesOFF.)
[Standby mode]: System keeps the standby status for 30 minutes.
(Standby status is released as powersupply
restoring, and the system restarts operating
immediately from the status right before power
failure.)
Battery pack
(Optional)
Lithium ion battery pack PT-E73BAT
(Not require the battery pack if not use resume function.)
USB(2.0)
4 ch (A type)
Serial Port
2ch (D-sub9pin, male)
(1ch is compatible with RS232C) (1ch is allowed to switch among
RS232C, RS422 and RS485)
Ethernet
(1000BASE-T/100BASE-TX/10BASE-T)
2 ch (*4)
PCI bus expansion slot
Expands PCI bus with an add-on unit.
CF card slot
2 slot (CF TypeI, II)
CF1 is finished mounting CF (1GB, 1 partition) *5
SSCNET
None
1 ch (14pin, female)
WDT/EMG
1 ch
(Watchdog Timer can be set from 0.1sec to 25.5sec andthe signal can
be output) (D-sub9 pin, female)
IDE Interface
1 ch (Only one device can be connected to master.)
External
Interface
(*2)
External DC output
5V/2A, 12V/1A (*2)
Reset button
Has
Operation LED
Has
LCD size (inch)
12.1
Resolution (dot)
SVGA
(800 x 600)
XGA
(1024 x 768)
SVGA
(800 x 600)
XGA
(1024 x 768)
brightness (cd/m
2
) 450
320
450
320
Life of backlight (Hr)
50,000
Exchanging of backlight
Exchangeable
LCD
display
function
(*3)
Backlight ON/OFF
Backlight ON/FF can be controlled by software.
(*1): For the model PT-E731HS, if it is using SSCNET communication, then Standby mode is unavailable.
(*2): Electrical currents that are supplied to external devices including those are connected to expansion slot, USB port
and external DC output should be 5V/2A, 12V/1A or less.
(*3): For the LCD resolution, there are about two dots upper and lower, right and left are masked by the protective
sheet. Therefore, please set the screen size in consideration of the masked range when creating a screen.
(*4): When using both 2CH Ethernets in 1000 BASE -T, please use PT-E under the environment where the operating
ambient temperature is “Front display section is 0°C to 40°C, other than display section is 0°C to 45°C”.
