Consilium Salwico CS4000, Installation Manual

Page: 98 / 277

Service & Maintenance manual Chapter 4: Replacing/Adding/Deleting fire detectors
Salwico CS4000
9
Hot Plug&Play (adding/deleting loop units)
The CS4000 system is equipped with a Hot Plug&Play
function enabling the user to add or delete detectors during
normal operation without the need to change the
configuration file with a PC and restarting the system.
The configuration file may be updated during normal
operation from service menu 6:5 or direct from the fault list,
menu 1.1.
This function is very useful, especially during installation. If
the CS4000 central detects additional or missing loop units,
they are simply added to/deleted from the configuration file
during normal operation.
Note : The changes to the configuration file is updated in the
RAM memory, but will not saved permanently until it has
been saved under:
Menu/ 6 Service menu/ 9 Save changes to
configuration . If the configuration file is not changed
permanently, any changes done will be lost if the system is
re-started.
Change configuration file from the fault list
Adding a loop unit from the fault list
If the CS4000 detects additional or missing loop units
compared to the configuration file, they are added to the fault
list.
1. Open the fault list: Menu/ 1 Fault alarms/ 1 Fault list
2. Select the detector to add from the list (fault no. 3 is
selected in the below example).
Loop Units generating fault no 152 (present not
configured) can be added to the systems
configuration.
FAULT ALARM 4(5)
________________________________________
3 LOOP 603 SMOKE HEAT 2 PRESENT NOT
CONFIGURED, FAULT(152)
.
Unit not found
.
4 ZONE 111 UNKNOWN LOOP DEVICE 3 NO
ANSWER, FAULT(128)
txt
5 LOOP ANALOGUE 601 CABLE BREAK
POSITIVE, FAULT(141)
Loop 1 on LB3 6
________________________________________
0=Add Loop Unit to configuration
OK=Details, 1=Print item, 2=Print all
3. Press 0=Add Loop Unit to configuration