Consilium Salwico CS4000, Installation Manual

Page: 26 / 277

Installation Manual
Chapter 3: Verification
Salwico CS4000
16
8. We recommend you to use a top to bottom procedure if you have
any problem with the verification of the loop function. Start by
solving the problems that affect the whole loop and thereafter
continue with the problems with each address.
Testing
After installation of the fire alarm system the different parts of the system
shall be tested to assure correct function. The CS4000 has a special test
mode, which makes the testing of detector zones easier. When a zone is in
test mode it will not activate any external alarm devices or controls in
case of a fire. Each tested detector and manual call point will indicate
activation with a red LED. The units in alarm will also be automatically
reset when the heat or smoke concentration is under the alarm level or if
the manual call point is reset. Fire alarms from zones not in test mode will
not be inhibited. Detectors and manual call points in the zone will blink
during test mode. The tested zone will automatically return to normal
operation after two hours.
Test a fire-detecting zone
Put the zone into test mode under:
menu/3 Disconnections/1 New
disconn./ 5 Test Mode
Enter the zone number and confirm with
OK
button
The indications DISC., Test and Zone/Unit will be lit to confirm the test
mode.
It is now safe to test each detector, manual call point etc in this fire zone
during two hours. Use suitable testing equipment.
All alarms will be listed under:
menu/7 History/1 Fire History List
Reset the test mode
After testing it is important to return the tested zone to normal condition
again. Make sure that there are no detectors or manual call points still in
alarm before leaving test mode.
The zones in test mode are listed in the disconnection list, found under:
menu/3 Disconnections /2 Disconnection list
.
Choose the zone in the disconnection list and then press
RESET
.
Test the control unit display
It is possible to test the alphanumerical display, all indications on the
control panel and the local buzzer with the function Test display, found
under:
menu/5 Settings/4 Test display
.