Consilium Salwico CS4000, Installation Manual

Page: 45 / 277

Installation Manual
Appendix C: Fault codes & Fuses
Salwico CS4000
1
168
RESTARTED
Something has restarted.
More info is given on
the control panel. If it happens repeatedly, contact our service
department.
169
TOO LONG BOOT
Exceeded the maximal
allowed boot time. If it happens repeatedly, contact our service
department.
170
EXTERNAL LOAD ON
LINE
There is a too high
external load on a
conventional zone. Locate the load and deal with it.
171
EXTERNAL SOURCE
ON LINE
Feeding voltage
detected on a
conventional zone. Locate the source and remove it.
172
LOW POWER SUPPLY
IN1
Low voltage on the
primary 24VDC power
supply to the internal
PCB’S. Check the power supply.
173
LOW POWER SUPPLY
IN2
Low voltage on the
secondary 24VDC
power supply to the
internal PCB’S. Check the power supply.
174
LOW POWER SUPPLY
LOCAL
Too low voltage on the
3.3V/5V feeding to the
internal circuit boards. Contact our service department.
175
LOW POWER SUPPLY
Too low incoming
24VDC supply to the
internal circuit boards. Check the power supply
The configuration file is
corrupt. Check the configuration file and re-configure the
system.
176
SYSTEM CONF FAULT
An error has occurred
during downloading of
the configuration file. Re-configure the system. If the fault remains,
contact our service dept.
177
LOW PRESSURE
External equipment
indicates low pressure. Check the pressure on the supervised unit.
178
ACTUATOR 1
Missing feedback from
actuator 1 Check cables to actuator 1. If the cables are OK,
change the actuator.
179
ACTUATOR 2
Missing feedback from
actuator 2. Check cables to actuator 2. If the cables are OK,
change the actuator.
209
WRONG TYPE OF UNIT
DEFINED
The type of unit
specified is different
from the type
configured. Change the unit or the system configuration.
210 ERROR IN
CAUSE&EFFECT
DEFINITIONS
Fault detected in the
configuration. Check the configuration.
255 ILLEGAL
Internal system error. Contact our service department.