Consilium Salwico CS4000, Installation Manual

Page: 136 / 277

CS4000 System boards
RB, Rectifier Board
Address switch
Specifications may be subject to change for improvement without prior notice Data sheet no: 462005e1 RB rectifier board 10 4 E
Page 2 of 3
Ç Consilium
Consilium Marine AB
P.O. Box 8763, SE-402 76 Göteborg
Phone +46 31 7107700 Fax +46 31 7107800
www.consilium.se
The 8-pole DIP switch is used to set the address for RB
Rectifier Board. Each board in a system has its own
unique address.
The address no. can be set from 1 to 255.
Example address switch setting:
1 2 3 4 5 6 7 8
O
N
1 2 4 8 16 32 64 128
Board adress no.
1+ 4+ 64= 69
Component & Terminal layout
Correct mounting of
connector P3 & P4
Male
Female
Jumpers
JP1
Programming mode. Fitted during programming of RB.
Move to JP4 when programming is completed.
JP2-JP3
Not used
JP4
Run mode, fitted during normal operation. Move to JP1
during programming of RB.
JP5
Battery charge boost. Fit jumper to increase battery
charge current from 0.25A to 1A.
Note : Max output
current (P3+P4) will then be decreased to max 2.25A.
Connectors
P1 Power in- and output.
P2 To transformer
P3 Internal system channel A to LB3/ZB.
P4 Internal system channel A to Base separate
power to bell outputs on Base Board.
P5 From transformer.
P6 Programmable relay output 1.
P7 Programmable relay output 2.
P8 Batteries
P9 Contact for download of software to RB.
P12 Internal system channel B
LEDs
D7 Relay 1. Green.
D10 System fault. Yellow.
D11 Relay 2. Green.
D23 TX data port 1. Green.
D24 RX data port 1. Green.
D27 TX data port 2. Green.
D28 RX data port 2. Green.
D31 Power to board OK. Green.
D33 Battery fault. Yellow.
D34 Forced battery charge. Green.
D35 Battery circuit OK. Green.
D36 Indicates battery test. Yellow.
Fuses
F3-F4 3.15AT To transformer
F5-F6 3.15AT To external mains
F8-F9 4 AF Battery
F10-F11 6.3AF From transformer
Fuse type: 5x20 m