Consilium Salwico CS4000, Installation Manual

Page: 35 / 277

Installation Manual
Chapter 5: Guidelines for fire alarm installations
Salwico CS4000
25
detection zone with SCI and therefore it is important to have it
close to where the cable changes to a new fire detection zone.
•
Installation shall preferably be hidden from the public but easily
accessible for service.
•
The short circuit isolators must be connected with correct
polarity.
Timers
•
The timer unit is used for temporary disconnection of detectors
in areas where smoke or heat can occur under normal
circumstances.
•
The timer should be mounted for easy access and operation and
well marked with its function.
•
For UR-2 type timer:
In addition to the loop address, the address interval for the
detectors to be disconnected must be set on the two extra DIP
switches in the timer.
Bells
•
Installation height normally 0.2 m from ceiling and max 2.2 m
from floor.
•
After installation, make sure that the cables are free from the
gong, otherwise the sound output will be reduced.
Electrical siren
•
Make sure to programme the siren to correct sound and
intermittence with the DIP switch inside the siren. More
information about how to set the DIP switch is found in the data
sheet for this unit.
•
Turn the volume control to max.
•
If the siren does not have a text clarifying the category of the
alarm (for example FIRE ALARM), it is recommended to mark
it accordingly.
Door holder magnet 65kp (650N)
•
Normally used for door leafs less than 1050 mm wide.
Door holder magnet 130kp (1300N)
•
Normally used for door leafs more than 1050 mm wide.
Door release switch
•
This switch is normally to be placed on both sides of each fire
door. Make sure it is not hidden behind the door leaf when door
is in open position.
•
Installation height normally 1.8 m above deck or floor level.